Philacric Modified Acrylic Primer
A general purpose rust preventive acrylic primer for steel surfaces in non-immersed areas. Philacric Modified Acrylic Primer displays very good compatibility with various well-known producers.
Quick drying, excellent corrosion resistance, excellent resistance to impact, oils, etc. Good workability. and chlorine free.
Color: Please refer to our color card
Solids: 48 ± 2
Coverage: Theoretical Coverage: 8.0 sq. m/Lit at 60 microns dry
Thickness: 60 microns dry / 130 microns wet
Flashpoint: > 25 °C
VOC: 470.0 g/Lit (material as into the container)
Mixing Ratio: Single pack product which should be stirred well before application by stirring machine.
Thinner: Not recommended. The material is ready for use, under special conditions use Thinner 400, max 5% by volume.
Painting Method: Airless spraying is our recommendation, brush, and spray follows. Tip range 0.48mm-0.53mm (21 thou), blowing pressure shouldn’t be less than 141kg / cm2 (2000psi). Additional thinner may be required. Use the proper equipment. Actual safety measures and precautions are very important from the selected method and environment work.
Cleaning: Power tool cleaning with Thinner PH 400.
Drying and Over-Coating Conditions
Philacric Modified Acrylic Primer should usually be over-coated with same types, and upgraded alkyd paints (PhilaLux). The recommended undercoat primers to be used are PhilaClor, Philacric Primer, and PhilaDur. Please consult Philadelphia Coatings LLC for further information.
All surfaces should be clean, dry and free from contamination. High pressure fresh water wash should be applied prior to the treatment of the application. For other surface treatments, please consult with our Philadelphia Coatings LLC Technical Department.
Circa 24 months at 20 °C, stored at dry, shaded and ventilated condition. The container/paint, must be kept sealed and away from heat and ignition.
5 Gal. (18,9 Lit) drum, 20 Lit drum. If other packing specifications are needed, please consult with Philadelphia Coatings LLC.
Health and Safety
Prior to use, obtain, consult and follow the Material Safety Data Sheet for this product concerning health and safety information. Read carefully and conform to precautions on MSDS and packing vessels. To avoid eye and skin contact, tools such as gloves, goggles and face mask etc. should be used during work with product (proper safety measures should be taken according to construction methods and circumstances). All work with the product must be carried out according to all relevant national health, safety and environment standards and codes. This product is for professional use only.
Limitation of Liability
All information is given for guidance only and is subject to regional variation depending upon local climate and environmental condition. An excessive film thickness delays the final curing and creates sagging. Over coating interval will increase with the number of paint layers and the thickness of the paint film. For recommended paints at special circumstances, please consult with our Philadelphia Coatings LLC. Apply in good weather. The relative humidity must not exceed 80% of the temperature of the surface to be coated must be at least 3°C above the dew point. All data from the tests is obtained under lab conditions, so Philadelphia Coatings LLC won’t bear any liabilities from the condition whether the data could reflect the objective status of the actual application circumstance or not.
The information in the product manual is based on our experiences from tests and practice. For the application without our knowledge, we could only make sure that our products themselves are warranted. We may modify the data in this product manual according to our continuous development and experience accumulation without advanced notice.