PhilaDur Transparent Sealer PTS 0/0

Overview

PhilaDur Transparent Sealer PTS 0/0 is a two-component, epoxy based resin system with a very durable polymer structure. It penetrates pores and capillary cracks and uses a self-leveling mechanism to create a proper undercoat condition for the next coating application such as PhilaDur PH 80 Anti-Abrasion. PhilaDur Transparent Sealer PTS0/0 displays very good compatibility with various well known producers.

Purpose

Applied as a sealer primer on concrete and cement finish surfaces before epoxy self leveling applications.

Properties

Color: Transparent

Solids: 56 ± 2

Application Data

Mixing Ratio: Basis 2 part per/volume, Curing Agent 1 part/volume.

Thinner: Not recommended

Painting Method: Brush or roller.

Cleaning: Power tool cleaning and Cleaners with Universal Thinner.

Pot Life: 2 hours at 23°C

Optimal Application Conditions: The temperature of the substrate should be minimum 3ºC above the dew point of the air. Good ventilation is required. Density: 1.01 ± 0.02 Kg/Lit Viscosity: 14 Sec (DIN 4).

Drying and Over-Coating Conditions

PhilaDur Transparent Sealer PTS 00.JPG

Coating Specification

Long overcoat period if temperatures are around freezing point. Proper selection of the systems, coating application procedures and surface preparation are made depending on actual existing film. Best specific design factors and conditions are tested in a controlled laboratory. Consult with Phila Coatings (USA) Inc. Technical Department before and throughout testing process.

Surface Preparation

All surfaces should be clean, dry and free from contamination. All loose and weak segments should be removed and concrete surfaces should be grinded down by using abrasive equipments in order to open the pores. Surface preparation must be accomplished properly to obtain better results. For other surface treatments, please consult with Phila Coatings (USA) Inc.

Storage

Circa 18 months at 25°C, stored at dry, shaded and ventilated condition. The container/paint, must be kept sealed and away from heat and ignition.

Pack Size

Basis 4 Gal. (16 Lit) 65.44 lb drum, agent 1 Gal (3,785 Lit) 4.2 lb drum. If other packing specifications are needed, please consult with Phila Coatings (USA) Inc.

Health and Safety

Prior to use, obtain, consult and follow the Material Safety Data Sheet for this product concerning health and safety information. Read carefully and conform to precautions on MSDS and packing vessels. To avoid eye and skin contact, tools such as gloves, goggles and face mask etc. should be used during work with product (proper safety measures should be taken according to construction methods and circumstances). All work with the product must be carried out according to all relevant national health, safety and environment standards and codes. This product is for professional use only.

Limitation of liability

All information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. An excessive film thickness delays the final curing and creates sagging. Over coating interval will increase with the increment of the number of paint layers and the thickness of the paint film. For recommended paints at special circumstances, please consult with our Phila Coatings (USA) Inc. Apply in good weather. The relative humidity must not exceed 80% temperature of the surface to be coated must be at least 3°C above the dew point. All data from the tests is obtained at the special lab circumstance, so Phila Coatings (USA) Inc. won’t bear any liabilities from the condition whether the data could reflect the objective status at the actual application circumstance or not.

Disclaimer

The information in the product manual is based on our experiences from tests and practice. For the application without our knowledge, we could only make sure that our products themselves are warranted. We may modify the data in this product manual according to our continuous development and experience accumulation without advanced notice.