PhilaTex Acrylic Waterborne Finish

Overview

A waterborne finish paint for exteriors and interiors. One-component waterborne, fast-drying, acrylic emulsion finish paint. Excellent block and weather resistance. Good hiding power, easy to apply. Particularly suitable when solvents are not permitted because of health and safety reasons PhilaTex Acrylic Waterborne Finish displays very good compatibility with various well-known producers.

Purpose

Water thinnable and non-flammable coating, quick drying, compatible with solvent based primers, good workability, excellent weathering resistance and gloss retention.

Properties

Sheen: High Gloss cosmetic

Color: White and various colors

Solids: 40 ± 2 40 (due to wide range of shades)

Coverage: Theoretical Coverage: 6.60 sq. m/Lit at 60 microns dry / 153 microns wet

Thickness: 60 microns dry

Flashpoint: < 61°C

VOC: > 75.00g/lit (material as into the container)

Application Data

Mixing Ratio: Single pack product which should be stirred well before application by stirring machine.

Thinner: Not recommended. The material is ready for use.

Painting Method: Airless spraying is our recommendation. Brush or roller, and spray follows. Tip range 0.48mm-0.53mm (21 thou), blowing pressure should not be less than 141kg / cm2 (2000psi). Use the proper equipment. Actual safety measures and precautions are very important from the selected method and environment work. Emergency Contact Numbers are available world wide upon any request.

Drying and Over-Coating Conditions

PhilaTex Acrylic Waterborne Finish.JPG

Surface Preparation

All surfaces should be clean, dry and free from contamination. High pressure fresh water wash should be applied prior to the treatment or of the application. For other surface treatments, please consult with Philadelphia Coatings LLC.

Storage

Circa 24 months at 20°C, stored at dry, shaded and ventilated condition. The container/paint must be kept sealed and away from heat and ignition.

Pack Size

5 Gal. (18,9 Lit) drum, 20 Lit drum. If other packing specifications are needed, please consult with Philadelphia Coatings LLC.

Health and Safety

Prior to use, obtain, consult and follow the Material Safety Data Sheet for this product concerning health and safety information. Read carefully and conform to precautions on MSDS and packing vessels. To avoid eye and skin contact, tools such as gloves, goggles and face mask etc. should be used during work with product (proper safety measures should be taken according to construction methods and circumstances). All work with the product must be carried out according to all relevant national health, safety and environment standards and codes. This product is for professional use only.

Limitation of liability

All information is given for guidance only and is subject to regional variation depending upon local climate and environmental condition. An excessive film thickness delays the final curing and creates sagging. Over coating interval will increase with the number of paint layers and the thickness of the paint film. For recommended paints at special circumstances, please consult with Philadelphia Coatings LLC. Apply in good weather. The relative humidity must not exceed 80% temperature of the surface to be coated must be at least 3°C above the dew point. All data from the tests is obtained under lab conditions, so Philadelphia Coatings LLC won’t bear any liabilities from the condition whether the data could reflect the objective status of the actual application circumstance or not.

Disclaimer

The information in the product manual is based on our experiences from tests and practice. For the application without our knowledge, we could only make sure that our products themselves are warranted. We may modify the data in this product manual according to our continuous development and experience accumulation without advanced notice.